SK Enterprises Manufacturer of Industrial Magnetizers & Magnetic Instruments — Maharashtra, India

Industry

Automotive & Two-Wheeler Components

Cars and two-wheelers use many permanent magnet parts, from wiper and window-lift motors to magneto flywheels and speed sensors. SK Enterprises builds magnetizers and fixtures that let component makers magnetize these parts after assembly, with repeatable results from batch to batch.

Key requirements

Key magnetizer requirements

01

Fixtures for two- and four-pole housings

Wiper, blower, window-lift and many starter motors use ferrite arcs inside a steel housing, magnetized radially from the inside.

02

Accurate multi-pole patterns

Magneto flywheels and sensor rings need several poles placed precisely, so the fixture must be built around the exact part.

03

High throughput with consistent results

Automotive volumes call for short cycle times, adequate fixture cooling and the same result on every pulse.

04

Checks that support traceability

Peak-current monitoring and flux or gauss testing give a measurable record that every part was magnetized.

Where magnetizers fit in automotive production

Automotive and two-wheeler components are built in high volumes, on lines where handling strong magnets causes real problems: parts jumping together, chipped ferrite and steel particles stuck inside housings. Assembling the magnets unmagnetized and leaving magnetization until the part is finished removes these issues and makes automatic loading far simpler.

Typical parts and how they are magnetized

Starter, wiper, blower and window-lift motors

These PMDC motors generally use ferrite arc magnets fixed inside a steel housing. A motor housing magnetizer fixture fits inside the housing and magnetizes the arcs radially from the inside, usually in two or four poles. The fixture locates the housing the same way every time, because pole position affects torque and noise.

Magneto flywheels

Two-wheeler magneto flywheels carry magnets on the inside of the flywheel cup. They are magnetized in a multi-pole pattern by a fixture placed inside the flywheel, which sets the number and position of the poles the generator is designed around.

Sensor magnets

Speed and position sensors use small ring, disc or block magnets, often with a precise multi-pole pattern. Our page on multi-pole magnetizers explains how pole count and accuracy are controlled.

Building a magnetizer station

A typical station pairs a capacitive discharge impulse magnetizer with one fixture per part type. The pulse lasts only a few milliseconds, but at automotive volumes fixture cooling and capacitor recharge time decide the real cycle rate. Peak-current monitoring can flag any part that did not receive a full pulse, and a gauss check at each pole confirms the result.

Before specifying a station, it helps to settle the magnet material, the hardest part to magnetize, the output per shift and the checks your customer expects. Our guide on how to choose a magnetizer walks through these decisions.

Enquire about automotive magnetizers

SK Enterprises is a magnetizer and fixture manufacturer based in Maharashtra, India. Share your part drawing, magnet material, pole layout and daily volume to start the discussion. Get a quotation for your part.

Relevant products

Products for automotive & two-wheeler components

FAQs

Frequently asked questions

Can a motor housing be magnetized after the magnets are glued in?

Yes, this is the usual method. A fixture inserted into the housing magnetizes all the arc magnets together in the required number of poles, so the magnets can be assembled unmagnetized.

How are magneto flywheels magnetized?

The magnets inside the flywheel cup are magnetized together by a multi-pole fixture placed inside the flywheel, so the fixture sets the pole count and pole positions.

Do different housing sizes need different fixtures?

Usually, yes. Each housing diameter, length and pole layout needs its own fixture, although one magnetizer can often drive several fixtures if its energy and voltage are sufficient.

Talk to our engineers about your requirement

Share what you need to magnetize — part, magnet material, pole pattern and output. We will recommend a machine and send a quotation.

WhatsApp Us