SK Enterprises Manufacturer of Industrial Magnetizers & Magnetic Instruments — Maharashtra, India

Application

Loose Magnet Magnetizer (Magnet Charging)

Loose magnet magnetization, usually called magnet charging, means that individual magnets are magnetized before they are packed, sold or assembled. It is the simplest magnetizer job: a solenoid coil, a capacitor discharge magnetizer and a holder that keeps each magnet in the right orientation.

When loose magnet charging is used

  • Magnet makers and traders charging stock before dispatch.
  • Assembly plants that fit pre-magnetized magnets, for example some interior-magnet rotor designs where magnets are charged before insertion.
  • Sensor and switch makers using small block, disc and ring magnets.
  • Testing and sampling, where a few magnets are charged and measured to check a batch.

How it works

The magnet sits in the bore of a magnetizer coil, a solenoid that produces a near-uniform field along its axis. A magnet charging machine discharges its capacitor bank through the coil in a pulse lasting a few milliseconds to magnetize the magnet through its thickness or length. For the physics behind the pulse, see how a capacitor discharge magnetizer works.

How much field is needed?

As a rough guide, ferrite saturates at about 1–1.5 T, sintered NdFeB at about 2.5–3.5 T and SmCo at about 3.5–5 T. A common rule of thumb is a field of about three times the magnet’s intrinsic coercivity (Hcj). Size the coil and machine for the hardest material you plan to charge, not the easiest.

Practical tips

  • Orientation: anisotropic magnets only reach full strength along their oriented direction, so holders should keep them aligned with the coil axis.
  • Polarity: decide which face should be north before you start, and mark or test parts consistently.
  • Handling after charging: charged magnets attract each other and any nearby steel. Collect them in non-magnetic trays with spacers to avoid chipping and pinched fingers.
  • Checking: a gauss meter reading on the face, or a fluxmeter with a Helmholtz coil, confirms that a batch is fully charged.

A coil magnetizes in one direction only. If your part needs several poles on one face or around its edge, it needs a shaped fixture instead; see multi-pole magnetizers.

Enquire about magnet charging

SK Enterprises manufactures magnet charging machines and coils in Maharashtra, India. Tell us the magnet materials, sizes and batch quantities you charge, and we will recommend a machine and coil. Request a quotation for a charging setup.

Relevant products

Products for loose magnet magnetizer (magnet charging)

FAQs

Frequently asked questions

In which direction will the magnet be magnetized?

In a solenoid coil the field runs along the coil axis, so the magnet is magnetized in the direction it is placed, usually through its thickness. Anisotropic magnets must be placed with their oriented direction along the coil axis.

Can I charge several magnets at once?

Often, yes, if they fit within the coil's uniform field region and the machine has enough energy. Use a non-magnetic holder and keep all the magnets in the same orientation.

Do I need a different coil for each magnet size?

Not always. One coil can charge a range of sizes up to its bore, but a large coil needs more energy to reach the same field, so matching coil size to your parts is more efficient.

Talk to our engineers about your requirement

Share what you need to magnetize — part, magnet material, pole pattern and output. We will recommend a machine and send a quotation.

WhatsApp Us